SupportCategory: Mantis PlatformHow do I connect the Turbidity probe to the Mantis SIP?
Support Staff asked 3 years ago
1 Answers
mantis Staff answered 3 years ago

Connecting the Turbidity probe
To connect the Turbidity probe to the Mantis Unit, you will need the Mantis Unit powered ON, the Turbidity probe and the connector cable. Make sure no other sensors are plugged into the red colored port on the Mantis Unit.
Step 1 – Locate the red colored port for the Mantis Unit.
mantis-sip-front-view2
Step 2 – Locate the Turbidity connection port.
turbidity-sensor-front-view-wmu
Step 3 – Locate the alignment arrow on the Turbidity probe connection end. Both ends of this connector cable are identical and either end can be used to connect to the Turbidity probe.
PICT0006-(2)
Step 4 – Gently connect the Turbidity sensor cable to the Turbidity Sensor with the alignment arrow aligned correctly with the sensor port. Make sure the pins and index arrow are correctly aligned, as damage may occur if the connectors are not aligned properly.  Firmly connect the Turbidity sensor cable to the Turbidity sensor when the alignment has been achieved.
turbidity-sensor-front-view-with-end-shown-plugged-in-2
Step 5 – Gently connect the second Turbidity sensor cable end to the red colored port on the Mantis Unit with the alignment arrow aligned correctly with the sensor port. Make sure the pins and index arrow are correctly aligned, as damage may occur if the connectors are not aligned properly.
PICT0045
Step 6 – Firmly connect the Turbidity sensor cable to the red colored port on the Mantis Unit when the alignment has been achieved. The Turbidity sensor is now ready to be used to collect your data!

Contact Us

We're not around right now. But you can send us an email and we'll get back to you, asap.

Not readable? Change text. captcha txt